LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Bracket Replacement - Left Side (2500 w/RPO LY6) >> Removal Procedure

Removal Procedure

CAUTION: When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.
    Fig 1: View Of Engine Mount Bracket Bolts
    GM1701018Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the left wheel house liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  5. Remove the engine mount to engine mount bracket bolts (1).
  6. Position an adjustable jack and a block of wood under the engine oil pan.
  7. Raise the engine slightly.
    8. Fig 2: View Of Engine Mount Bracket & Bolts
    GM1701674Courtesy of GENERAL MOTORS COMPANY
  8. Remove the engine mount bracket through bolts.
  9. Remove the engine mount bracket.
scientia non olet · About LEMON Manuals