LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

    Fig 1: View Of Drive Belt Tensioner & Bolts
    GM1696654Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner to the water pump.
    2. NOTE: Refer to Fastener Notice .
  2. Install and tighten the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals