LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt idler pulley to the generator bracket and tighten the idler pulley bolt finger tight.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals