LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the J 42386-A  (1) and bolts. See Special Tools . Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

    Tighten:  Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).

  2. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
    3. Fig 2: View Of CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Camshaft Position Actuator Removal and Installation Caution .
  3. Remove the CMP actuator solenoid valve (234).
  4. Discard the solenoid valve.
scientia non olet · About LEMON Manuals