LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: The gasket surface should be free of oil or other foreign material during assembly.
    Fig 1: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
  2. Install the CMP actuator magnet (752) to the front cover.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP actuator magnet bolts (751).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  4. Connect the engine harness electrical connector to the CMP actuator magnet.
  5. Install the water pump. Refer to Water Pump Replacement (RPOs LY2/LC9/LY5/LMG/LFA) or Water Pump Replacement (RPOs LY6/L76/L92) .
scientia non olet · About LEMON Manuals