LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6 Inch axle) or Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    6. Fig 1: View Of Wheel Speed Sensor Ring, Axle Housing & Removal Tool
    GM889095Courtesy of GENERAL MOTORS CORP.
  6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857  (1) and the J 2619-01  (2).
scientia non olet · About LEMON Manuals