Circuit/System Testing

Verify that DTC C0710 is not set.
- If the DTC is set, refer to DTC C0710 .
Ignition OFF, disconnect the harness connector at the yaw rate/lat sensor.
Ignition OFF for 60 seconds, test for less than 5 ohms between the low reference circuit terminal 1 and ground.
- If greater than the specified range, test the low reference circuit for an open/high resistance.
Ignition ON, test for B+ between the ignition voltage circuit terminal 4 and ground.
- If not within the specified range, test the ignition voltage circuit for a short to ground or open/high resistance.
If all circuits test normal, replace the yaw rate/lat sensor.