Transmission Mount Replacement (2WD)

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transmission Mount, Crossmember Nut & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Support the transmission with a transmission jack.
1	Transmission Mount to Crossmember Nut NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Transmission Mount Bolt (Qty: 2) Tighten: 50 N.m (37 lb ft)
3	Transmission Mount Tip: Raise the transmission with the transmission jack just enough to remove the transmission mount.