Rear Brake Hose Replacement (Frame to Rear Axle JH6)

Fig 1: Rear Brake Hose (Frame to Rear Axle JH6)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Brake Dust Caution . CAUTION: Refer to Brake Fluid Irritant Caution . Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Brake Pipe Fitting (Qty: 2) NOTE: Refer to Fastener Notice . Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten: 25 N.m (18 lb ft)
2	Hose Bracket to Frame Bolt (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Brake Pipe Fitting (Qty: 2) Procedure Remove any dirt or debris from the brake pipe fittings. Cap the brake pipe fittings to prevent brake fluid loss and contamination. Tighten: 25 N.m (18 lb ft)
4	Hose to Rear Axle Bolt Tighten: 25 N.m (18 lb ft)
5	Rear Brake Hose Assembly Procedure: Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .