Front Brake Hose Replacement (JD9)

Fig 1: Front Brake Hose Replacement (JD9)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Brake Dust Caution . CAUTION: Refer to Brake Fluid Irritant Caution . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Wheel Speed Sensor Wire Clip
2	Hose Bracket to Control Arm Bolt NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
3	Wheel Speed Sensor Wire Clip
4	Brake Pipe Fitting Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten: 25 N.m (18 lb ft)
5	Hose Bracket to Frame Bolt Tighten: 9 N.m (80 lb in)
6	Brake Hose Fitting Bolt Tighten: 40 N.m (30 lb ft)
7	Brake Hose Fitting Gasket (Qty: 2) Procedure Discard the brake hose fitting gaskets. Install 2 new brake hose fitting gaskets.
8	Brake Hose Procedure: Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .