LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gages >> Diagnostic Information and Procedures >> Speedometer and/or Odometer Inaccurate or Inoperative >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, perform the speedometer gage sweep test with the scan tool. Verify that the speedometer gage sweeps from its low to high position.
    • If the speedometer gage does not sweep from its low to high position, replace the IPC.
  2. Ignition OFF, raise the vehicle drive wheels.
  3. Engine ON, transmission in drive or 1st gear, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
    • If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
scientia non olet · About LEMON Manuals