Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor ring using the J 45860 (1) and the GE-8092 Driver Handle (2).
- Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
- Install the axle shaft bearing using the J 23690 (1) and the GE-8092 Driver Handle (2).
- Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
- Install the axle shaft seal using the J 21128 .
- Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
- Install the axle shaft. Refer to Rear Axle Shaft Replacement .
- Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) , Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
- Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Fill the rear axle. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
- Lower the vehicle.