LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Rear Wheel Speed Sensor Electrical Connector And Harness Clips
    GM2178526Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wheel speed sensor electrical connector (1).
  3. Release the wheel speed sensor electrical connector and sensor harness clips (2) from the inboard frame rail.
    4. Fig 2: Rear Wheel Speed Sensor Bolt
    GM2178527Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel speed sensor bolt (1).
    5. Fig 3: Rear Wheel Speed Sensor
    GM2178528Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel speed sensor (1) from the rear axle.
scientia non olet · About LEMON Manuals