Body Rear Corner Garnish Molding Replacement - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Body Rear Corner Garnish Molding - Right Side

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the rear opening garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
1	Body Rear Corner Upper Garnish Molding Cover Procedure Disconnect the 2 electrical connectors.
2	Body Rear Corner Upper Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Body Rear Corner Upper Garnish Molding Assembly TIP: During installation move the liftgate weatherstrip outward slightly to ensure the garnish trim is installed behind the weatherstrip.
4	Body Rear Corner Upper Garnish Molding Clip (Qty: 3)
5	Body Rear Corner Upper Garnish Molding Retainer (Qty: 3)