LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Selector Cable Bracket And Cable
    GM777649Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission range selector cable bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the transmission range selector cable bracket bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 2: View Of Retainer Securing Cable To Bracket
    GM858985Courtesy of GENERAL MOTORS CORP.
  3. Align and install the cable to the bracket.
  4. Install the retainer that secures the cable to the bracket.
  5. Lower the vehicle.
  6. Check the vehicle for proper operation. If cable adjustment is necessary, refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals