LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Turbine Shaft Seal Installation >> Installation

Turbine Shaft Seal Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Turbine Shaft Oil Seal Rings
    GM1601754Courtesy of GENERAL MOTORS CORP.
  1. Use the J 36418-1B  (1) in order to install the four turbine shaft oil seal rings (619). See Special Tools .
  2. Resize oil seal rings (619) after installation:
    1. Place J 36418-2A  (2) over the turbine shaft oil seal rings (619) and seat against input housing. See Special Tools .
    2. Remove J 36418-2A  (2). See Special Tools .
    3. Turn J 36418-2A  (2) upside down and place over the turbine shaft oil seal ring (619). See Special Tools .
    4. Seat against input housing.
    5. Leave J 36418-2A  (2) in place over the turbine shaft oil seal rings (619) until the reverse input clutch housing is installed. See Special Tools .
scientia non olet · About LEMON Manuals