LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Reverse Input Clutch Disassemble >> Disassemble

Reverse Input Clutch Disassemble: Disassemble

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Reverse Input Clutch Plates
    GM181579Courtesy of GENERAL MOTORS CORP.
  1. Remove the reverse input clutch retaining ring (614).
  2. Remove all reverse input clutch plates (611-613).
    3. Fig 2: View Of Reverse Input Clutch Spring Retainer Ring
    GM59352Courtesy of GENERAL MOTORS CORP.
  3. Install the J 23327-1  and the J 25018-A  . See Special Tools .
  4. Compress the reverse input clutch spring assembly.
  5. Remove the reverse input clutch spring retainer ring (610).
    6. Fig 3: Identifying Reverse Input Clutch Spring & Piston Assemblies
    GM7880Courtesy of GENERAL MOTORS CORP.
  6. Remove the reverse input clutch spring assembly (609).
  7. Remove the reverse input clutch piston assembly (607).
scientia non olet · About LEMON Manuals