LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Shaft Installation >> Installation

Output Shaft Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft
    GM588787Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.
  1. Install the output shaft (687).
    2. Fig 2: Identifying Special Tool J29837-A & Output Shaft O-Ring Seal
    GM1730029Courtesy of GENERAL MOTORS CORP.
  2. Install the J 29837-A  as shown. See Special Tools . Support the output shaft (687) with adjustable stop (1).
scientia non olet · About LEMON Manuals