LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Oil Pump Removal >> Removal

Oil Pump Removal: Removal

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Pump Bolts & Seals
    GM1730033Courtesy of GENERAL MOTORS CORP.
  1. Remove all pump bolts (2) and pump bolt seal (3).
  2. Install J 45053  over stator shaft. See Special Tools . Tighten the clamp bolts (1).
  3. To prevent slipping, securely fasten the J 45053  around the stator shaft by tightening the bolts (1) with a wrench. See Special Tools .
    4. Fig 2: Locating Pump Assembly
    GM1730035Courtesy of GENERAL MOTORS CORP.
  4. Turn the T-handle of the J 45053  to pull the pump assembly (4) from the case. See Special Tools .
  5. Lift the pump (4) out of the case.
    6. Fig 3: View Of Fluid Pump Seal & Gasket
    GM1552919Courtesy of GENERAL MOTORS CORP.
  6. Remove the fluid pump seal (5).
  7. Remove the pump cover to case gasket (6).
scientia non olet · About LEMON Manuals