LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Oil Pump Cover Assemble >> Assemble

Oil Pump Cover Assemble: Assemble

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Special Tools J 39855, J 38735-3 & Stator Shaft Oil Seal Rings
    GM1552963Courtesy of GENERAL MOTORS CORP.
  1. Using the J 39855-1 (1) which is part of kit J 39855  and the J 38735-3  (3), install the stator shaft oil seal rings (230). See Special Tools .
  2. Place J 39855-2 (2) which is part of kit J 39855  over the seals. See Special Tools .
  3. Leave J 39855-2 (2) which is part of kit J 39855  on the stator shaft until just before the pump is to be installed into the transmission. See Special Tools .
    4. Fig 2: Identifying Pressure Relief Bolt Valve components
    GM1730055Courtesy of GENERAL MOTORS CORP.
  4. Install the pressure relief ball (228) and pressure relief spring (229).
  5. Install the pressure relief bolt rivet (227).
  6. Install the oil pump cover screen seal (231) on the oil pump cover screen (232).
  7. Install the oil pump cover screen (232) into the pump cover.
    8. Fig 3: Identifying Converter Clutch Valve Components
    GM1552952Courtesy of GENERAL MOTORS CORP.
  8. Install the converter clutch valve spring (246).
  9. Install the converter clutch valve (224).
  10. Install the stop valve (223) and the oil pump converter clutch valve retaining ring (222).
    11. Fig 4: View Of Oil Pump Cover & Components
    GM1552951Courtesy of GENERAL MOTORS CORP.
  11. Install the pressure regulator valve (216).
  12. Install the pressure regulator isolator spring (218) and the pressure regulator valve spring (217).
  13. Install the reverse boost valve (219) in the reverse boost valve sleeve (220).
  14. Install the reverse boost valve and sleeve in the pump cover.
  15. Install the oil pump reverse boost valve retaining ring (221).
scientia non olet · About LEMON Manuals