LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Oil Pump Body Assemble >> Assemble

Oil Pump Body Assemble: Assemble

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Seal Assembly
    GM1552946Courtesy of GENERAL MOTORS CORP.
  1. Using the J 25016  (1), install the oil seal assembly (243). See Special Tools .
    2. Fig 2: View Of Fluid Seal Retainer
    GM1730051Courtesy of GENERAL MOTORS CORP.
  2. Install the fluid seal retainer (244).
    3. Fig 3: Identifying O-Ring Seal & Oil Seal Ring
    GM1552949Courtesy of GENERAL MOTORS CORP.
  3. Install an O-ring seal (202) and oil seal ring (201) into the groove on the back side of the pump slide (203).
  4. Use J 36850  , or an equivalent, to retain the seal and the ring on the slide. See Special Tools .
  5. Install the pivot pin spring (204) into the pump body pocket.
  6. Install the seal support (208) and the pump slide seal (209) into the pump slide (203). Retain with J 36850  or equivalent. See Special Tools .
  7. Install the pump slide (203).

    The oil seal ring must face downward into the pump pocket.

  8. Install the pivot pin (205), index the slide notch with the pivot pin.
    9. Fig 4: Identifying Fluid Pump slide Outer Spring
    GM1552950Courtesy of GENERAL MOTORS CORP.
  9. Install the fluid pump slide outer spring (245).
    10. Fig 5: Identifying Oil Pump Rotor & Pump Vane Rings
    GM1552937Courtesy of GENERAL MOTORS CORP.
  10. Install the rotor guide (211) and the bottom pump vane ring (210) into the rotor (212) and retain with J 36850  or an equivalent. See Special Tools .
  11. Install the rotor (212) with the rotor guide (211) toward the pump pocket.
  12. Install the pump vanes (213). Ensure the vanes are flush with the oil pump body surface.
  13. Install the top pump vane ring (210).
scientia non olet · About LEMON Manuals