LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Low and Reverse Clutch Piston Installation >> Installation

Low and Reverse Clutch Piston Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transmission Seals Onto Low & Reverse Clutch Piston
    GM5708Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission (low and reverse clutch outer, center, inner) seals (696) on the low and reverse clutch piston (695).
  2. Lubricate the seals with assembly lubricant J 36850  or an equivalent. See Special Tools .
    3. Fig 2: Aligning Parking Brake Pawl Window With Notch In Piston
    GM5498Courtesy of GENERAL MOTORS CORP.
  3. Install the low and reverse clutch piston (695) into the case. The notch in the piston must be aligned with the parking brake pawl window, in the case.
    4. Fig 3: View Of Low And Reverse Clutch Spring Assembly & Retainer Ring
    GM59269Courtesy of GENERAL MOTORS CORP.
  4. Install the low and reverse clutch spring assembly (694).
    1. Using the J 23327-1  , compress the low and reverse clutch spring assembly (694). See Special Tools .
    2. Using J 36850  install the low and reverse clutch retainer ring (693). See Special Tools .
scientia non olet · About LEMON Manuals