LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Internal Transmission Speed Sensor Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressing Internal Speed Sensor Rotor Onto Output Shaft
    GM5472Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not re-use an internal speed sensor rotor that has been removed.
  1. Slip a new internal speed sensor rotor (699) over the output shaft splines.
  2. Install the J 36352-4  in the groove on the output shaft (687). See Special Tools .
  3. Place the J 36352-6  on the output shaft (687). See Special Tools . Press on the J 36352-6  until it contacts the J 36352-4  in the window (the J 36352-4  will be a positive stop for the J 36352-6  ). See Special Tools .
scientia non olet · About LEMON Manuals