LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> 2-4 Servo Cover and Assembly Removal >> Removal

2-4 Servo Cover and Assembly Removal: Removal

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing J 29714-A
    GM5426Courtesy of GENERAL MOTORS CORP.
  1. Install the J 29714-A  . See Special Tools .
    2. Fig 2: Compressing Servo Cover With J 29714-A
    GM5427Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If cover does not move inwards with tool, use a block of wood or suitable material and lightly tap on cover using a hammer to free up cover in bore.
  2. Tighten the J 29714-A  bolt to compress the servo cover. See Special Tools .
    3. Fig 3: Locating Servo Cover Retaining Ring
    GM207613Courtesy of GENERAL MOTORS CORP.
  3. Remove the servo cover retaining ring (29) and the J 29714-A  . See Special Tools .
    4. Fig 4: View Of 2-4 Servo Assembly
    GM207615Courtesy of GENERAL MOTORS CORP.
  4. Remove the servo cover (28) and O-ring seal (27). If the servo cover seems to be hung up on the seal, cut and remove the O-ring seal before removing the cover.
  5. Remove the 2-4 servo assembly.
scientia non olet · About LEMON Manuals