1-2 Accumulator Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Valve Body Bonded Spacer Plate

Courtesy of GENERAL MOTORS CORP.

Inspect the valve body bonded spacer plate for damage or debris.

Fig 2: Locating #1 Checkball

Courtesy of GENERAL MOTORS CORP.

Install the number 1 checkball into the case.

Fig 3: Aligning Valve Body Bonded Spacer Plate

Courtesy of GENERAL MOTORS CORP.

Install the J 25025-5 into the case. See Special Tools .

IMPORTANT: Do not reuse the bonded spacer plate. Replace with a NEW bonded spacer plate.

Place the bonded spacer plate on the case.

Fig 4: View Of Spacer Plate Support Plate & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the spacer plate support plate (53 or 113).
Install the spacer plate support bolts (77).

NOTE: Refer to Fastener Notice .

Install the accumulator bolt (115), model dependent.
Tighten: Tighten the accumulator bolt to 11 N.m (8.11 lb ft).

Fig 5: View Of 1-2 Accumulator Housing And Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 1-2 accumulator housing assembly (57) or gasket (114) and housing (116).
Install the 1-2 accumulator housing bolts (58, 59 or 117, 118).
Tighten:
- Tighten the bolts 58 and 59 to 11 N.m (8 lb ft).
- Tighten the bolts 117 and 118 to 8-14 N.m (6-10 lb ft).