Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2)

Fig 1: View Of Front Seat Adjuster Outer Finish Cover, Recliner Cover & Manual Lumbar Knob

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Recliner Lever Procedure: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.
2	Front Seat Manual Lumbar Knob Procedure: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
3	Front Seat Adjuster Outer Finish Cover NOTE: Refer to Fastener Notice . Procedure Remove the screw from front of the cover. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover. Pull outward to release the retainers from the seat assembly. Disconnect the electrical connectors. Tighten: 2 N.m (18 lb in)

Callout

Component Name

Front Seat Recliner Lever
Procedure:
Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.

Front Seat Manual Lumbar Knob
Procedure:
Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.

Front Seat Adjuster Outer Finish Cover

NOTE: Refer to Fastener Notice .

Procedure

Remove the screw from front of the cover.
Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
Pull outward to release the retainers from the seat assembly.
Disconnect the electrical connectors.

Tighten: 2 N.m (18 lb in)