Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase)

Fig 1: View Of Body Side Trim Panel Assembly & Retainers

GM1657788

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures

Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
Remove the third row folding seat if equipped. Refer to Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) or Rear Number 2 Seat Replacement (Suburban/Yukon XL) .
Remove the rear opening garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
Remove the back rear corner upper garnish molding. Refer to Body Rear Corner Garnish Molding Replacement - Right Side .
Remove the rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement (Standard Wheelbase) or Rear Side Door Sill Plate Replacement (Extended Wheelbase) .
Remove the body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) or Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase) or Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) .

1

Body Side Trim Panel Assembly
Tip:

Align the 4-way locator to the body side inner and then the 2-way locator to the body back opening.
Disconnect the electrical connector.

2

Body Side Trim Panel Retainer (Qty: 9)