Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase)

Preliminary Procedures

1. Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
2. Remove the third row seats. Refer to Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) or Rear Number 2 Seat Replacement (Suburban/Yukon XL) .
3. Remove the rear opening garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
4. Remove the back rear corner upper garnish molding. Refer to Body Rear Corner Garnish Molding Replacement - Right Side .
5. Remove the rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement (Standard Wheelbase)  or Rear Side Door Sill Plate Replacement (Extended Wheelbase) .
6. Remove the body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT)  or Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase)  or Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) .

1. Align the locators to the body side inner panel prior to engaging the retainers.
2. Disconnect the electrical connector.