Windshield Wiper Arm Replacement (Flat Blade )
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Open the hood in order to access and remove the wiper arm assembly. |
|
| 1 | Windshield Washer Arm Finish Cap Tip: Use a small flat-bladed tool to remove the finish cap. |
| 2 | Windshield Washer Arm Nut
NOTE:
Refer to Fastener Notice
. Tip: Hold the wiper blade arm tip to the vertical black bar target mark located at the lower center portion of the windshield wile securing the nut. Tighten: 35 N.m (26 lb ft) |
| 3 | Windshield Washer Arm Hose Tip: Rotate the hose clockwise around the end of the washer wiper arm upon installation. |
| 4 | Windshield Washer Arm Assembly Tip: Use the J 39637 Wiper Arm Remover Tool. See Special Tools . |
| 5 | Windshield Washer Blade Assembly Tip: Pinch the 2 outer tabs on the arm, rotate the blade rearward and slide the blade forward to release the wiper blade from the wiper arm assembly. |