LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of IPC & Screws
    GM1224708Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable.
  2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement .
  3. Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
  4. Disconnect the HUD electrical connector from the IPC.
  5. Remove the IPC to steering column bracket retaining screws.
  6. Raise the rear of the IPC slightly, then lift the IPC to access the electrical connector.
  7. Disconnect the IPC electrical connector.
  8. Remove the IPC.
scientia non olet · About LEMON Manuals