LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> DTC P1617 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the engine oil level switch.
  2. Ignition OFF, test for less than 1 ohm of resistance between the ground circuit and ground.
    • If greater than 1 ohm, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Engine Oil Level Switch parameter is Low.
    • If not Low, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Ignition ON, install a 3A fused jumper wire between the signal circuit and ground. Verify the scan tool Engine Oil Level Switch parameter is Ok.
    • If not Ok, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the engine oil level switch.
scientia non olet · About LEMON Manuals