LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> DTC P0608 >> Circuit/System Testing

Circuit/System Testing

IMPORTANT: The drive wheels of the vehicle must be raised and the transmission must be placed in drive or first gear. Refer to Lifting and Jacking the Vehicle .
  1. Ignition OFF, disconnect the C1 harness connector at the radio.
  2. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
    • If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the radio.
  3. Ignition OFF, disconnect the harness connector at the rear object detection control module.
  4. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
    • If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the rear object sensor control module.
  5. Ignition OFF, disconnect the harness connector at the head-up display (HUD).
  6. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
    • If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the HUD.
  7. Ignition OFF disconnect the C1 harness connector at the engine control module.
  8. Ignition ON, test for 9-11 volts between the vehicle speed signal circuit and ground.
    • If less than 9 volts, test the vehicle speed signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the IPC.
    • If greater than 11 volts, test the vehicle speed signal circuit for a short to voltage. If the circuit tests normal, replace the IPC.
  9. If all circuits test normal, test or replace the ECM.
scientia non olet · About LEMON Manuals