Special Tools
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 GMC Yukon XL, 2006 GMC Sierra, 2006 GMC Savana Special, 2006 GMC Savana Camper Special, and 2006 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 3289-20 Holding Fixture Base Assembly |
|
| J 6116-01 Rear Gear Holding Fixture |
|
| J 6125-1B Slide Hammer |
|
| J 6129 Handle |
|
| J 7057 Dial Indicator Plunger Extension |
|
| J 8001 Dial Indicator Set |
|
| J 8763-02 Transmission Holding Fixture |
|
| J 21362-1 Direct and Forward Clutch Piston and Inner Seal Protector |
|
| J 21363 Intermediate Clutch Inner Seal Protector |
|
| J 21364-A Rear Gear Holding Fixture Adapter |
|
| J 21366 Converter Holding Strap |
|
| J 21368 Pump Body and Cover Alignment Band |
|
| J 21370-10 Band Apply Pin Gauge |
|
| J 23093 Center Support Alignment Tool |
|
| J 23129 Universal Seal Remover |
|
| J 23327 Clutch Spring Compressor |
|
| J 24396 Intermediate Clutch Pack Alignment Tool |
|
| J 25018-A Clutch Spring Compressor Adapter |
|
| J 25025-B Dial Indicator Post and Guide Pin Set |
|
| J 25025-1 Guide Pins |
|
| J 25025-5 Guide Pins |
|
| J 26900-13 Magnetic Indicator Base |
|
| J 28585 Snap Ring Remover |
|
| J 36850 Assembly Lubricant |
|
| J 38358-A Forward Clutch Assembly Remover/Installer |
|
| J 38655 Holding Fixture Adapter |
|
| J 38693 Oil Pump Seal and Rear Lube Seal Installer |
|
| J 38694 Extension Housing Seal Installer |
|
| J 38695 Direct Clutch Spiral Retaining Ring Installer |
|
| J 38729 Overrun Clutch Piston Seal Protector |
|
| J 38731-1 Fourth Clutch Piston and Housing Seal Protector |
|
| J 38731-2 Fourth Clutch Piston and Housing Seal Protector |
|
| J 38731-3 Fourth Clutch Piston and Housing Seal Spacer |
|
| J 38732-1 Direct and Forward Clutch Piston and Outer Seal Protector |
|
| J 38733 Direct Clutch Assembly Remover/Installer |
|
| J 38734 Intermediate Spring Compressor Adapter |
|
| J 38736-1 Turbine Shaft Seal Installer |
|
| J 38736-2 Turbine Shaft Seal Installer |
|
| J 38736-3 Turbine Shaft Seal Sizer |
|
| J 38736-4 Turbine Shaft Seal Sizer |
|
| J 38736-5 Turbine Shaft Seal Pusher |
|
| J 38736-6 Turbine Shaft Seal Pusher |
|
| J 38737 Band Apply Pin Checking Tool |
|
| J 38868-A Output Shaft Assembly Remover/Installer |
|
| J 38869 Rear Extension Seal Installer |
|
| J 38882 Fourth Clutch Spring and Retainer Assembly Adapter |
|
| J 39195 Converter End Play Check Tool |
|
| J 39919-1 Center Support Thread Reamer |
|
| J 39919-2 Center Support Gage Pin |
|
| J 41505 Output Shaft Seal Installer |
|
| J 45053 Universal Clamp Press |