LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 789 (Automatic Transmission - 4L80-E/4L85-E - Overhaul) >> Repair Instructions >> Control Valve Body Assembly Removal

Control Valve Body Assembly Removal

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 GMC Yukon XL, 2006 GMC Sierra, 2006 GMC Savana Special, 2006 GMC Savana Camper Special, and 2006 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid pressure manual valve position switch (TFP manual valve position switch) bolts (76) and the TFP manual valve position switch (40).
    Fig 1: TFP Manual Valve Position Switch
    GM54538Courtesy of GENERAL MOTORS CORP.
  2. Remove the control valve body assembly bolts (35).
    Fig 2: View Of Control Valve Assembly
    GM54542Courtesy of GENERAL MOTORS CORP.
  3. Remove the manual shift shaft detent spring assembly (41).
  4. Remove the control valve body assembly bolt (35) and the lube oil pipe retainer (37).
  5. Remove the lube oil pipe (39).
  6. Remove the control valve assembly (44) including the following:
    • The 3rd and 4th clutch accumulator housing (51)
    • The control valve body gasket (45) (not shown)
    • The control valve body spacer plate (46) (not shown)
    • The accumulator housing gasket (47) (not shown)
  7. Remove the manual valve (319) from the control valve assembly to prevent damage.
    Fig 3: Locating Manual Valve
    GM1300594Courtesy of GENERAL MOTORS CORP.
  8. Inspect the manual valve (319) for nicks and burrs.
  9. Remove the control valve body spacer plate gasket (48) from the case. The gasket may stick to the spacer plate.
    Fig 4: View Of Control Valve Body Spacer Plate Gasket & TCC Solenoid Valve Screen Assembly
    GM28385Courtesy of GENERAL MOTORS CORP.
    10. IMPORTANT: The TCC solenoid valve screen assembly can be removed easily by applying light pressure at the bottom of the screen.
  10. Remove the TCC solenoid valve screen assembly (75) from the case passages.
  11. Inspect the TCC solenoid valve screen assembly (75) for debris and damage.
    12. NOTE: Do not use a magnet in order to remove the control valve body ball check valves. This may magnetize the control valve body ball check valves, causing metal particles to stick to them.
    Fig 5: View Of Control Valve Body Ball Check Valves
    GM828381Courtesy of GENERAL MOTORS CORP.
  12. Remove the 8 control valve body ball check valves (54).
scientia non olet · About LEMON Manuals