Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

No MAF DTC P0101, P0102 or P0103.
No MAP sensor DTC P0106, P0107 or P0108.
No TP sensor DTC P0120 or P0220.
No VSS DTC P0502 or P0503.
No ISS DTC P0716 or P0717.
No TCC Stuck Off DTC P0741.
No 1-2 SS valve DTC P0751, P0752 or P0753.
No 2-3 SS valve DTC P0756, P0757 or P0758.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid DTC P2761.
Throttle angle is 5-100 percent.
The TFT is 20-130°C (68-266°F).
The TFP manual valve position switch is D4.
The engine torque must be 95-542 N.m (70-400 lb ft).
Vehicle speed is 2 km/h (0.5 mph) or greater.
The MAP is 0-105 kPa (0-15 psi).
The engine is running for more than 7 seconds.
The system voltage is between 10-18 volts for more than 0.5 seconds.