Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

No MAF DTC P0101, P0102, or P0103.
No MAP sensor DTC P0106, P0107, or P0108.
No TP sensor DTC P0120 or P0220.
No VSS DTC P0502 or P0503.
No ISS DTC P0716 or P0717.
No TCC Stuck On DTC P0742.
No shift solenoid electrical DTC P0753 or P0758.
No transmission component slipping DTC P0894.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P2761.
Not in 4WD Low.
The engine is running for greater than 7 seconds.
The system voltage is between 8-18 volts for more than 0.5 seconds.
Transmission ISS is greater than 7 RPM.
Transmission OSS is greater than 7 RPM.
The TP sensor is greater than 10 percent.
The engine torque must be 108-542 N.m (80-400 lb ft).
No TFP manual valve position switch change within 6 seconds.
The TFP manual valve position switch indicates D4.
The transmission fluid temperature (TFT) is 20-130°C (68-266°F).
The engine vacuum is 0-105 kPa (0-15 psi).