Conditions for Running the DTC
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- No MAP sensor DTC P0106, P0107, or P0108.
- No TP sensor DTC P0121, P0122 or P0123.
- No VSS DTC P0502 or P0503.
- No ISS DTC P0716 or P0717.
- No TCC DTC P0741 or P2761.
- No transmission component slipping DTC P0894.
- No TFP manual valve position switch DTC P1810.
- The system voltage is between 8-18 volts for more than 0.5 seconds.
- The speed ratio is 0.95-2.18.
- The engine torque must be 169-576 N.m (125-425 lb ft).
- The transmission fluid temperature (TFT) is 20-130°C (68-266°F).
- No TFP manual valve position switch change within 6 seconds.
- The TFP manual valve position switch indicates D4.
- The commanded gear is not 1st.
- Engine speed is 800-4,400 RPM.
- The throttle position (TP) is 12-100 percent.
- The vehicle speed is 11-121 km/h (7-75 mph).
- The engine vacuum is 0-105 kPa (0-15 psi).