Fluid Passage Plug Kit Installation

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fluid Passage Plug Kit Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Special Tools: DT-49291: Clutch Travel Air Passage Plug Kit
1	Compensator Feed Fluid Passage - Outer Procedure: Install the tapered oval fluid passage plug DT-49291-4 which is part of DT-49291: clutch travel air passage plug kit, into the compensator feed fluid passage hole on the 1-2-3-4 and 3-5 reverse clutch support assembly. Tip: The compensator feed fluid passage hole is the top outer hole on the 1-2-3-4 and 3-5 reverse clutch support assembly.
2	Compensator Feed Fluid Passage - Inner Procedure: Install the round fluid passage plug DT-49291-5 which is part of DT-49291: clutch travel air passage plug kit, into the compensator feed fluid passage hole inside the 1-2-3-4 and 3-5 reverse clutch support assembly. Tip: The compensator feed fluid passage hole is the middle inner hole in the 1-2-3-4 and 3-5 reverse clutch support assembly.
3	1-2-3-4 and 3-5 Reverse Clutch Housing Assembly Procedure Ensure that the 1-2-3-4 clutch plates, backing plate and retaining ring are installed. Install the 1-2-3-4 and 3-5 reverse clutch housing onto the torque converter (with fluid pump) housing assembly. Install the applicable plug kit sleeve DT-49291-2 (6L80/6L90) or DT-49291-3 (6L45/6L50), cap DT-49291-1, bolt, washer and nut which are all part of DT-49291: clutch travel air passage plug kit.