Torque Converter Housing with Fluid Pump Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Converter Housing with Fluid Pump Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: The valve body assembly must be removed prior to removing the torque converter (with fluid pump) housing assembly. Failure to ensure this will cause severe damage to both fluid pump seal assemblies. Also, the load of the valve body pushing on the seals, which in turn push on the pump, may prevent proper pump installation into the case. Refer to Control Valve Body Assembly Removal .
1	Turbine Shaft (O-ring) Seal
2	Bolt M10 x 50 (Qty: 9)
3	Torque Converter (With Fluid Pump) Housing Assembly
4	Fluid Pump Seal