LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Upper Intake Manifold Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Sight Shield Retainer & Bolts
    GM1696801Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the intake manifold sight shield on top of the intake manifold, aligning the holes, if required.
  2. Install the intake manifold sight shield retainer bolts, if required.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    3. Fig 2: View Of Upper Intake Manifold Sight Shield
    GM1696760Courtesy of GENERAL MOTORS CORP.
  3. Install the intake manifold sight shield tabs into the slots in the retainer.
  4. Align the intake manifold sight shield grommets with the studs.
  5. Gently push down on the intake manifold sight shield over the grommets, seating the intake manifold sight shield.
  6. Close the hood.
scientia non olet · About LEMON Manuals