LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Engine Mount Replacement - Right Side (2500 LY6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701903Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount to the engine.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS CORP.
  2. Install the two top engine mount to engine bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 3: Locating Tab On Engine Block
    GM1963125Courtesy of GENERAL MOTORS CORP.
  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack from the engine block lifting tab (1).
    5. Fig 4: View Of Engine Mount To Frame Bolts
    GM1701898Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount to frame bolts (1).

    Tighten:  Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.

  6. Install the starter motor. Refer to Starter Motor Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
    7. Fig 5: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS CORP.
  7. Install the two lower engine mount to engine bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  8. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals