LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 970 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Test Plug
    GM1649737Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the oil pressure test plug.

    Tighten:  Tighten the oil pressure test plug to 11 N.m (97 lb in).

  2. Check the transmission fluid level (fill if necessary). Refer to Transmission Fluid Check .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals