Torque Converter Housing with Fluid Pump Installation

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Torque Converter Housing & Fluid Pump Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	NEW Fluid Pump Seal
2	Torque Converter (with Fluid Pump) Housing Assembly NOTE: Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
3	Bolts M10 x 50 (Qty: 9) NOTE: Refer to Fastener Notice . Procedure: Tighten in the sequence shown. Tighten: 72 N.m (53 lb ft)
4	NEW Turbine Shaft (O-Ring) Seal