Tools Required

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

J 21368 Pump Body and Cover Alignment Band. See Special Tools .

Fig 1: View Of Oil Pump Cover & Oil Pump Body

Courtesy of GENERAL MOTORS CORP.

Place the oil pump cover onto the oil pump body and put stator shaft through a hole in the bench.
Install the pump cover bolts (233) finger tight only.

Fig 2: Identifying Pump Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Install the J 21368 . See Special Tools .

NOTE: Refer to Fastener Notice

Tighten the pump cover bolts (233).
Tighten: Tighten the bolts to 24 N.m (18 lb ft).
Remove the J 21368 . See Special Tools .