LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 969 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Internal Transmission Speed Sensor Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressing Internal Speed Sensor Rotor Onto Output Shaft
    GM5472Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not re-use an internal speed sensor rotor that has been removed.
  1. Slip a new internal speed sensor rotor (699) over the output shaft splines.
  2. Install the J 36352-4  in the groove on the output shaft (687). See Special Tools .
  3. Place the J 36352-6  on the output shaft (687). See Special Tools . Press on the J 36352-6  until it contacts the J 36352-4  in the window (the J 36352-4  will be a positive stop for the J 36352-6  ). See Special Tools .
scientia non olet · About LEMON Manuals