Seat Belt Retractor Pretensioner Replacement - Front (Extended Cab)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Seat Belt Retractor Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . CAUTION: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws. Preliminary Procedures Disable the SIR. Refer to SIR Disabling and Enabling . Remove front door sill plate. Refer to Front Side Door Sill Plate Replacement (Regular Cab/Crew Cab) or Front Side Door Sill Plate Replacement (Extended Cab) . Remove rear door sill plate. Refer to Rear Side Door Sill Plate Replacement (Extended Cab) or Rear Side Door Sill Plate Replacement (Crew Cab) .
1	Front Seat Belt Retractor Trim Cover
2	Front Seat Belt Retractor Bolt NOTE: Refer to Fastener Notice . Tip: Disconnect electrical connector. Tighten: 45 N.m (33 lb ft)
3	Front Seat Shoulder Belt Guide Plug
4	Front Seat Shoulder Belt Guide Bolt Tighten: 45 N.m (33 lb ft)
5	Front Seat Adjuster Finish Cover
6	Front Seat Shoulder Belt Anchor Plate Bolt Tighten: 45 N.m (33 lb ft)
7	Front Seat Shoulder Belt Retractor Assembly