LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1847 (Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW) >> Diagnostic Information and Procedures >> DTC C0710 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the high resistance condition due to terminal fretting corrosion.

  1. Ignition ON.
  2. Verify the scan tool Steering Wheel Position parameter corresponds to the actual steering wheel position as the steering wheel is turned through its entire range of motion.
    • If the parameter does not correspond with the steering wheel position or the reading is erratic 

      Refer to Circuit/System Testing below.

    • If the parameter reading corresponds with the steering wheel position 
  3. Verify the scan tool Digital HWPS Index Pulse parameter cycles between Low and High as the steering wheel is centered and then turned through its entire range of motion.
    • If the parameter does not cycle between Low and High as the steering wheel is turned 

      Refer to Circuit/System Testing below.

    • If the parameter cycles between Low and High as the steering wheel is turned 
  4. All OK
scientia non olet · About LEMON Manuals