Circuit/System Testing
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, open the hood to disable the Auto Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- Crank the engine for up to 30 seconds.
- Observe the vehicle DTC information with a scan tool.
- If any of the following DTCs are set, diagnose these DTCs first: DTC P0117, P0118, P0122, P0123, P0201-P0208, P0222, P0223, P0335, P0336, P0351-P0358, P0562, P0563, P0601-P0604, P0606, P0607, P062F, P0633, P0685, P0690, P1631, P1682, P16F3, or P2610. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- With the ignition ON and the engine OFF, test the fuses that are supplied ignition 1 voltage by the powertrain relay. The test lamp should illuminate ON for each test point of the fuses.
- If the test lamp does not illuminate ON for at least one test point of each fuse, refer to DTC P0685 or P0690 .
- Crank the engine for 15 seconds. Observe the engine speed parameter with a scan tool.
- If engine RPM is not indicated, refer to DTC P0335 .
- Install a spark plug tester onto one ignition module/coil assembly on each bank of the engine.
- Observe both spark plug testers.
- Crank the engine for 15 seconds. The ignition coil secondary voltage should be observed across the gap of both spark plug testers.
- If the ignition coil secondary voltage is not observed, is inconsistent, or weak on either spark plug tester, refer to Electronic Ignition System Diagnosis .
- With the ignition ON and the engine OFF, command the fuel pump ON and OFF with the scan tool. The fuel pump should energize when commanded ON, and de-energize when commanded OFF.
- If the fuel pump does not turn ON and OFF, refer to Fuel System Diagnosis (w/o FPCM) or Fuel System Diagnosis (w/FPCM) .
- Turn OFF the ignition.
- Install the J 34730-1A Fuel Pressure Gage. With the ignition ON and the engine OFF, command the fuel pump ON several times with the scan tool. Refer to Fuel System Diagnosis for the fuel pressure specification.
- Inspect for the following conditions:
- Compare the actual engine coolant temperature to the ECT parameter.
- Filter and air intake system for restrictions and obstructions
- Test the fuel for contamination-Refer to Alcohol/Contaminants-in-Fuel Diagnosis (without Special Tool) or Alcohol/Contaminants-in-Fuel Diagnosis (with Special Tool) .
- Inspect the spark plugs-Refer to Spark Plug Inspection .
- Test the exhaust system for restrictions-Refer to Restricted Exhaust .
- Engine mechanical conditions, such as worn timing chain, sprocket gears, low compression, etc.-Refer to Symptoms - Engine Mechanical .
NOTE:
An erratic or weak spark is considered a no spark condition.