LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1152 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Vent Hose Replacement (Rear Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose Assembly
    GM1983368Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose assembly to the vehicle.
  2. Connect the vent hose (4) to the vent tube (1).
  3. Raise the transmission to the installed position.
  4. Install new tie straps (5) to secure the vent hose to the transmission wiring harness. Do not collapse the vent hose while tightening the tie straps.
  5. Install the transmission support. Refer to Transmission Support Replacement (Manual Transmission) or Transmission Support Replacement (Automatic Transmission) .
  6. Remove the jack.
  7. Install the vent hose retainers (6) located on the mount assembly.
  8. Lower the vehicle.
  9. Install the vent hose to the retainer (3) to the rear of the right cylinder head (2).
    10. Fig 2: View Of Air Inlet Housing
    GM1848887Courtesy of GENERAL MOTORS CORP.
  10. Install the air inlet housing front panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals