Upper to Lower Control Valve Body Assembly
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Upper to Lower Control Valve Body Assembly
| Callout | Component Name |
|---|---|
| 1 | Control Valve Body Ball Check Valve (Qty: 7)
NOTE:
Do not use any type of grease or other material to hold the check ball valves in place during assembly. Grease will cause the valves to not operate properly, resulting in damage to the transmission. Tip: Refer to Ball Check Valve Locations . |
| 2 | Control Valve Body Spacer (w/Gasket) Plate Assembly
NOTE:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
|
| 3 | Control Valve Lower Body Assembly Tip: Turn the valve body assembly over after installing to upper body. |
| 4 | Bolt M5 x 36 (Qty: 12)
NOTE:
Refer to Fastener Notice
. Procedure: Tighten the bolts in the sequence shown. Tighten: 8 N.m (71 lb in). |